Rotogro

Usage Instructions

1. Fill reservoir with fresh water adjusting ph to 5.00. Place 4" cubes in reservoir and let soak for 24 hours.
2. Place cuttings into pre soaked 4" cubes and load into trays.
3. Adjust lamps between 18 to 24 hours. (Your preference).Let plants spin for 3 to 4 days making sure they do not dry out.
4. Fill reservoir 2 way with fresh water and adjust ph between 5.6 - 5.8. Add nutrients to a reading of 500 ppm.
5. On the 4th day or if plants are drying out, flood top reservoir until the bottom (about 1") of the cube is covered. Adjust the overflow to that depth.
6. Leave the pump on until all trays have passed through.
7. After a couple of days, check cubes for roots protruding through the bottom.
8. Check ph in reservoir (between 5.6 - 5.8) and adjust overflow so the entire cube is flooded.
9. Flood every 2nd to 3rd day for approximately 1 week. (average veg time is 10 days). Switch timer to 12 hours.
10. Adjust nutrients to 1000-1200 ppm and flood daily as lamps turn on. As plants increase in size, adjust nutrients to compensate. It is recommended to change reservoir water weekly.
11. You should oxygenate the water with an air stone and pump.You can add a circulating pump to continuously mix and agitate the nutrient water mixture.
12. Place a fan in the direction of opening and blow across plants to help C02 movement.
13. For optimum light, keep glass tube clean by spraying a glass cleaner onto a towel and wiping tube. This is best done when lamps are just turning on or off.